Metal Lathe Accessories
Work Holding
- 5“ Pratt Burnerd 3 jaw chuck - this is very good, look after it.
- 5” 4 jaw independent chuck
- A wooden ways board to protect the ways when changing the chuck or fitting heavy work.
- Drive plate for turning between centres.
- Travelling steady.
- Fixed steady.
Tailstock
- Live centre for tailstock - good but a bit blunt.
- Dead centre - with carbide tip.
- Half dead centre.
- Keyless Chuck for Tailstock.
- Morse taper reducing sleeves.
Cutting
- Parting off tools.
- Some Carbide insert cutting tools.
- Lots of HSS for making cutting tools.
- Some reamers
Measurement and Metrology
- A digital Metric indicator and small stand.
- A dial test indicator.
- An imperial dial indicator and stand.
- Digital callipers - on loan from Drew.
- Large and Small precision Levels .
Thread Cutting
- Tap Follower.
- Die Holder.
- A range of thread cutting carbide tools.
- Change gears in the bottom draw for a wider range of screw cutting options.
Misc
- A turret stop to go on the carriage.