This is an old revision of the document!
Metal Lathe - Harrison M250
UNDER CONSTRUCTION
Induction Required
This equipment requires an induction prior to use. For your own safety and to avoid damage to the equipment do not attempt to use it until you have been inducted.Crush / Laceration / Entanglement
This equipment is hazardous to the user or those around them, take care during use.PPE Required
This equipment requires the use of eye protection during use.Introduction
The Harrison M250 lathe (also sold as Colchester Bantam with a different gear change and control lever layout) was designed to appeal to schools, training establishments, repair shops and those needing a strong, properly-built but compact lathe for light production work.
The M250 is a full-function machine capable of the entire range of turning operations, and through the available range of
accessories its scope and versatility can be increased even further. Quality, reliability and response make it one of the most
outstanding lathes of its kind especially in industry, the toolroom, training and secondary and tertiary education.
- Easy to understand headstock mounted speed, threading and feed charts
- Smooth power transmission through a twin vee belt drive and induction hardened and ground headstock gearing
- Large saddle and slide bearing areas for precision and long life
- Deep section top slide with dovetail guides and gib strip adjustment
- The combination box section cast iron bed and rigid steel base provides an incredibly strong structure
- A huge selection of accessories are available
Induction to use the Lathe
To request an induction please post on the forum. The induction takes about 1.5 hours.
Pre-Induction Study:
If you are new to lathe work, please prepare for the induction by watching the first 5 videos of BlondieHacks Lathe Skills on youtube (apx 35 minutes).
We highly recommend the whole series.
Here is the list of currently authorised inductors and inducted members.
Specification
- 290mm Swing Over Bed
- 180mm Swing Over Cross Slide
- 525mm Between Centres
- 35mm Spindle Bore
- No. 3 D1 Camlock nose
- 40-2000rpm Spindle Speeds
- Quick change gear head
- 0.9kW Motor
- Quick change tool post
- Metric and imperial thread cutting
- Power feed on main carriage and cross slide
Manual
Accessories
- 5“ 3 jaw chuck
- 6” 4 jaw independent chuck
6“ 4 jaw self aligning chuck← This, seems to have disappeared, if you know where it is please put it under the lathe.
- Travelling steady
- Fixed steady
- Rotating centre for Tailstock
- Keyless Chuck for Tailstock
Maintenance Notes and Current To Do list
See the forum thread for the Metal Lathe Team.
Safety
Safety must be adhered to at all times.
Link to the risk assessment.
Maintenance
Daily maintenance is to be carried out on each occasion the lathe is used.
This section to be updated
In the event of anything urgent please Post on the forum or contact Drew or someone from the committee.
In the event of the lathe being unsafe to use clearly mark it explaining why to warn other members and alert on the forum or contact the committee on committee@bristol.hackspace.org.uk