Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
| equipment:metalshop:metallathe:accessories [2024/07/22 13:28] – drew | equipment:metalshop:metallathe:accessories [2025/01/21 21:20] (current) – drew | ||
|---|---|---|---|
| Line 6: | Line 6: | ||
| *A wooden ways board to protect the ways when changing the chuck or fitting heavy work. | *A wooden ways board to protect the ways when changing the chuck or fitting heavy work. | ||
| *Drive plate for turning between centres.\\ | *Drive plate for turning between centres.\\ | ||
| - | *Travelling steady.\\ | ||
| - | *Fixed steady.\\ | ||
| ===Tailstock=== | ===Tailstock=== | ||
| Line 16: | Line 14: | ||
| *Morse taper reducing sleeves.\\ | *Morse taper reducing sleeves.\\ | ||
| - | ===Cutting== | + | |
| + | ===Steady Rests=== | ||
| + | *Travelling steady rest.\\ | ||
| + | *Fixed steady rest - Below are a couple of great videos explaining how to set up and use the fixed steady. \\ | ||
| + | {{youtube> | ||
| + | {{youtube> | ||
| + | |||
| + | ===Cutting=== | ||
| *Parting off tools. \\ | *Parting off tools. \\ | ||
| *Some Carbide insert cutting tools. \\ | *Some Carbide insert cutting tools. \\ | ||
| Line 32: | Line 37: | ||
| ===Thread Cutting=== | ===Thread Cutting=== | ||
| *[[equipment: | *[[equipment: | ||
| + | *Tap Follower.\\ | ||
| + | *Die Holder.\\ | ||
| + | *A range of thread cutting carbide tools. | ||
| *Change gears in the bottom draw for a wider range of screw cutting options.\\ | *Change gears in the bottom draw for a wider range of screw cutting options.\\ | ||
| ===Misc=== | ===Misc=== | ||
| - | *A turret stop to go on the carridge. | + | *A turret stop to go on the carriage. |