Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
| equipment:woodshop:woodcnc [2026/07/21 08:41] – dave | equipment:woodshop:woodcnc [2026/09/11 10:22] (current) – fraserh | ||
|---|---|---|---|
| Line 52: | Line 52: | ||
| * Metal | * Metal | ||
| * Humans | * Humans | ||
| + | |||
| + | ====== Tools Provided ====== | ||
| + | |||
| + | To aide members in using the CNC for the first time we have provided a small selection of tools. These tools were selected because they match tools within the Carbide Create Tool Library making it easier to program you tool paths. | ||
| + | |||
| + | The tools provided are: | ||
| + | |||
| + | <WRAP 600px left> | ||
| + | ^ Bit Type ^ Mill Size ^ Carbide3D Bit Equivalent ^ | ||
| + | | Flat Endmill | 1/4 Inch Cut - 1/4 Inch Shank | 201 | | ||
| + | | Flat Endmill | 1/8 Inch Cut - 1/8 Inch Shank | 102 | | ||
| + | | Ball Endmill | 1/4 Inch Cut - 1/4 Inch Shank | 202 | | ||
| + | | Ball Endmill | 1/8 Inch Cut - 1/8 Inch Shank | 101 | | ||
| + | | V-Bit | 90 Degree | 301 | | ||
| + | | V-Bit | 60 Degree | 302 | | ||
| + | | Downcut Flat Endmill | 1/4 Inch Cut - 1/4 Inch Shank | 251 | | ||
| + | </ | ||
| + | <WRAP clear/> | ||
| + | |||
| + | We would recommend that anyone planning to use the CNC more that once should look at purchasing their own tools. | ||
| ====== Usage Insturctions ====== | ====== Usage Insturctions ====== | ||
| Line 108: | Line 128: | ||
| NOTE: Don't over tighten the clamps as they will pull the clamping point through the spoil board. | NOTE: Don't over tighten the clamps as they will pull the clamping point through the spoil board. | ||
| + | {{: | ||
| ====4. Probing your Stock Location==== | ====4. Probing your Stock Location==== | ||