Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
| equipment:woodshop:woodcnc [2026/06/08 18:21] – matt | equipment:woodshop:woodcnc [2026/07/21 08:43] (current) – dave | ||
|---|---|---|---|
| Line 105: | Line 105: | ||
| Tip: Use bolts of the correct length to fix the clamps to the spillboard. If the bolts are too long they will bottom out in the threaded holes. | Tip: Use bolts of the correct length to fix the clamps to the spillboard. If the bolts are too long they will bottom out in the threaded holes. | ||
| + | |||
| + | NOTE: Don't over tighten the clamps as they will pull the clamping point through the spoil board. | ||
| + | |||
| + | {{: | ||
| ====4. Probing your Stock Location==== | ====4. Probing your Stock Location==== | ||