Differences

This shows you the differences between two versions of the page.

--- equipment:woodshop:woodcnc [2026/06/04 13:20] – dave
+++ equipment:woodshop:woodcnc [2026/09/11 10:22] (current) – fraserh
@@ Line 1: / Line 1: @@
-======Wood CNC - Shapeoko 3 XL -Not yet commissioned======
+======Wood CNC - Shapeoko 3 XL ======
 <callout title="Induction Required" type="danger" icon="true">This equipment requires an induction prior to use. For your own safety and to avoid damage to the equipment do not attempt to use it until you have been inducted.</callout>
@@ Line 52: / Line 52: @@
   * Metal
   * Humans
+====== Tools Provided ======
+To aide members in using the CNC for the first time we have provided a small selection of tools. These tools were selected because they match tools within the Carbide Create Tool Library making it easier to program you tool paths.
+The tools provided are:
+<WRAP 600px left>
+^ Bit Type ^ Mill Size ^ Carbide3D Bit Equivalent ^
+| Flat Endmill | 1/4 Inch Cut - 1/4 Inch Shank | 201 |
+| Flat Endmill | 1/8 Inch Cut - 1/8 Inch Shank | 102 |
+| Ball Endmill | 1/4 Inch Cut - 1/4 Inch Shank | 202 |
+| Ball Endmill | 1/8 Inch Cut - 1/8 Inch Shank | 101 |
+| V-Bit | 90 Degree | 301 |
+| V-Bit | 60 Degree | 302 |
+| Downcut Flat Endmill | 1/4 Inch Cut - 1/4 Inch Shank | 251 |
+</WRAP>
+<WRAP clear/>
+We would recommend that anyone planning to use the CNC more that once should look at purchasing their own tools.
 ====== Usage Insturctions ======
@@ Line 105: / Line 125: @@
 Tip: Use bolts of the correct length to fix the clamps to the spillboard. If the bolts are too long they will bottom out in the threaded holes.
+NOTE: Don't over tighten the clamps as they will pull the clamping point through the spoil board.
+{{:equipment:woodshop:woodcnc:spoilboard_clamp_issue.jpg?400|}}
 ====4. Probing your Stock Location====