Differences

This shows you the differences between two versions of the page.

--- equipment:woodshop:woodcnc [2025/11/26 21:24] – dave
+++ equipment:woodshop:woodcnc [2026/05/15 11:06] (current) – dave
@@ Line 8: / Line 8: @@
 <callout title="PPE Required" type="primary" icon="true">This equipment requires the use of eye protection / hearing protection / respiratory protection during use.</callout>
+====Cutting Items====
+  * Hard wood
+  * Soft wood
+  * MDF
+  * Plywood
+  * Acrylic
+  * Delryn
+====Banned Items====
+  * Metal
 ====== Shapeoko 3 XL – Common CNC Terms ======
@@ Line 133: / Line 144: @@
 Make sure the clamps don’t block the toolpath and use bolts of the correct length — too long and they can bottom out in the threaded holes. Tighten evenly so the stock sits flat and secure.
-====Dave====
+====Walkthrough====
 Turn on isolator and boot raspberry PI.
@@ Line 202: / Line 213: @@
 Then press start on next screen
-Spindle will move to front right and the screen will ask you to fit your first bit, fit bit, make sure bit doesn’t stick out lower than the bitsetter measurer. you might need to adjust height of dust shoe.
+Spindle will move to front right and the screen will ask you to fit your first bit, fit bit, make sure bit doesn’t stick out lower than the bitsetter measurer which is the grey box with a silver button at the bottom right os the CNC.
 Fit the dust shoe, close doors and press resume.
@@ Line 225: / Line 236: @@
 {{:equipment:woodshop:woodcnc:5_jog.png?400|}}
-===End Dave===