Differences

This shows you the differences between two versions of the page.

--- equipment:woodshop:woodcnc [2025/11/26 21:21] – dave
+++ equipment:woodshop:woodcnc [2026/03/04 20:58] (current) – dave
@@ Line 8: / Line 8: @@
 <callout title="PPE Required" type="primary" icon="true">This equipment requires the use of eye protection / hearing protection / respiratory protection during use.</callout>
+====Cutting Items====
+  * Hard wood
+  * Soft wood
+  * MDF
+  * Plywood
+  * Acrylic
+  * Delryn
+====Banned Items====
+  * Metal
 ====== Shapeoko 3 XL – Common CNC Terms ======
@@ Line 133: / Line 144: @@
 Make sure the clamps don’t block the toolpath and use bolts of the correct length — too long and they can bottom out in the threaded holes. Tighten evenly so the stock sits flat and secure.
-====Dave====
+====Walkthrough====
 Turn on isolator and boot raspberry PI.
@@ Line 206: / Line 217: @@
 Fit the dust shoe, close doors and press resume.
+{{:equipment:woodshop:woodcnc:19_fit_dust_shoe.jpg?400|}}
 {{:equipment:woodshop:woodcnc:18_tool_change.png?400|}}
-{{:equipment:woodshop:woodcnc:19_fit_dust_shoe.jpg?400|}}
 Spindle will spin up and there will be a message to set the speed dial. If the dial is correct just hit resume, if you need to change it open the door, the spindle will stop, set the speed, close the door and hit resume
@@ Line 226: / Line 236: @@
 {{:equipment:woodshop:woodcnc:5_jog.png?400|}}
-===End Dave===