Differences

This shows you the differences between two versions of the page.

--- equipment:woodshop:woodcnc [2025/11/26 21:00] – dave
+++ equipment:woodshop:woodcnc [2025/11/26 21:25] (current) – dave
@@ Line 133: / Line 133: @@
 Make sure the clamps don’t block the toolpath and use bolts of the correct length — too long and they can bottom out in the threaded holes. Tighten evenly so the stock sits flat and secure.
-====Dave====
+====Walkthrough====
 Turn on isolator and boot raspberry PI.
@@ Line 173: / Line 173: @@
 {{:equipment:woodshop:woodcnc:8_corner.png?400|}}
+{{:equipment:woodshop:woodcnc:9_begin_probe.png?400|}}
 Remove magnet and probe plate when it asks you to remove ground clip.
-{{:equipment:woodshop:woodcnc:9_begin_probe.png?400|}}
+{{:equipment:woodshop:woodcnc:10_remove_magnet.jpg?400|}}
+{{:equipment:woodshop:woodcnc:11_bit_setter.jpg?400|}}
 Make sure you are clear from the CNC as the head will move then you click OK.
-{{:equipment:woodshop:woodcnc:10_remove_magnet.jpg?400|}}
+{{:equipment:woodshop:woodcnc:12_bit_zero_ok.png?400|}}
 Go back to run menu
-{{:equipment:woodshop:woodcnc:11_bit_setter.jpg?400|}}
 Plug in USB stick and click cancel to the popup.
@@ Line 193: / Line 193: @@
 {{:equipment:woodshop:woodcnc:14_load_file.png?400|}}
+{{:equipment:woodshop:woodcnc:15_open_file.png?400|}}
+{{:equipment:woodshop:woodcnc:16_done.png?400|}}
 press start job.
@@ Line 199: / Line 201: @@
 Then press start on next screen
-{{:equipment:woodshop:woodcnc:5_jog.png?400|}}
 Spindle will move to front right and the screen will ask you to fit your first bit, fit bit, make sure bit doesn’t stick out lower than the bitsetter measurer. you might need to adjust height of dust shoe.
-{{:equipment:woodshop:woodcnc:18_tool_change.png?400|}}
 Fit the dust shoe, close doors and press resume.
 {{:equipment:woodshop:woodcnc:19_fit_dust_shoe.jpg?400|}}
+{{:equipment:woodshop:woodcnc:18_tool_change.png?400|}}
 Spindle will spin up and there will be a message to set the speed dial. If the dial is correct just hit resume, if you need to change it open the door, the spindle will stop, set the speed, close the door and hit resume
+{{:equipment:woodshop:woodcnc:20_spindle.jpg?400|}}
 {{:equipment:woodshop:woodcnc:21_resume.png?400|}}
-{{:equipment:woodshop:woodcnc:20_spindle.jpg?400|}}
 The first job will start and start cutting.
@@ Line 226: / Line 225: @@
 {{:equipment:woodshop:woodcnc:5_jog.png?400|}}
-===End Dave===