Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
| equipment:woodshop:woodcnc [2026/04/27 16:52] – matt | equipment:woodshop:woodcnc [2026/04/27 17:05] (current) – matt | ||
|---|---|---|---|
| Line 124: | Line 124: | ||
| * If the Raspberry Pi is not already running, press the silver button to boot it up.\\ | * If the Raspberry Pi is not already running, press the silver button to boot it up.\\ | ||
| * Rotate the emergency stop button clockwise to reset it, if required.\\ | * Rotate the emergency stop button clockwise to reset it, if required.\\ | ||
| + | |||
| + | ==== Pre-Useage Checks ==== | ||
| + | |||
| * Open the machine doors and check that the drive belts look in good condition, with no cuts of frays.\\ | * Open the machine doors and check that the drive belts look in good condition, with no cuts of frays.\\ | ||
| * Check that there is no thick dust build up on top of the big silver gantry' | * Check that there is no thick dust build up on top of the big silver gantry' | ||
| * Check that there is nothing left loose inside the enclosure that could jam the movement of the router. | * Check that there is nothing left loose inside the enclosure that could jam the movement of the router. | ||
| + | * Check the fire extinguisher is present in the woodshop. | ||
| ==== Starting the Software and Initialising the Machine ==== | ==== Starting the Software and Initialising the Machine ==== | ||