Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
| equipment:woodshop:woodcnc:spoilboard [2026/07/21 20:27] – dave | equipment:woodshop:woodcnc:spoilboard [2026/07/21 20:27] (current) – dave | ||
|---|---|---|---|
| Line 8: | Line 8: | ||
| Disable bit setter in menu | Disable bit setter in menu | ||
| + | |||
| Remove bit setter use tape to mark location. | Remove bit setter use tape to mark location. | ||
| + | |||
| Probe to corner of spoil board. | Probe to corner of spoil board. | ||
| + | |||
| Install bit. | Install bit. | ||
| + | |||
| Move head into middle of board and use paper method to set the zero to the top of the spoil board. | Move head into middle of board and use paper method to set the zero to the top of the spoil board. | ||
| + | |||
| Run job. | Run job. | ||
| + | |||
| Rerun if any pencil lines remain. | Rerun if any pencil lines remain. | ||