Differences

This shows you the differences between two versions of the page.

--- equipment:woodshop:woodcnc:spoilboard [2026/07/21 13:12] – fraserh
+++ equipment:woodshop:woodcnc:spoilboard [2026/07/21 20:27] (current) – dave
@@ Line 6: / Line 6: @@
 {{ :equipment:woodshop:woodcnc:cnc_spoil_board.zip |}}
+Disable bit setter in menu
+Remove bit setter use tape to mark location.
+Probe to corner of spoil board.
+Install bit.
+Move head into middle of board and use paper method to set the zero to the top of the spoil board.
+Run job.
+Rerun if any pencil lines remain.