Differences

This shows you the differences between two versions of the page.

--- equipment:woodshop:woodcnc:spoilboard [2025/05/28 14:06] – created fraserh
+++ equipment:woodshop:woodcnc:spoilboard [2026/07/21 20:27] (current) – dave
@@ Line 1: / Line 1: @@
+====== How to make a new spoil board for the Shapeoko 3 Wood CNC ======
 This page will go through the process to make a new spoil board.
+But in the meantime, below is the Carbide Create file that has the design of the spoil board, including toolpaths to cut out and surface the spoil board.
+{{ :equipment:woodshop:woodcnc:cnc_spoil_board.zip |}}
+Disable bit setter in menu
+Remove bit setter use tape to mark location.
+Probe to corner of spoil board.
+Install bit.
+Move head into middle of board and use paper method to set the zero to the top of the spoil board.
+Run job.
+Rerun if any pencil lines remain.