Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
| equipment:woodshop:routertabletriton [2025/01/26 20:50] – matt | equipment:woodshop:routertabletriton [2025/01/27 15:02] (current) – sammyc | ||
|---|---|---|---|
| Line 113: | Line 113: | ||
| **Steps** | **Steps** | ||
| - | * There is an interlock that prevents the collet being lifted above the table whilst the router is switched on. Therefore before the collet can be lifted above the table this switch must be " | + | * There is an interlock that prevents the collet being lifted above the table whilst the router is switched on. Therefore before the collet can be lifted above the table this switch must be " |
| - | * There is a switch on the router behind a transparent slide. This is under the table on the same side as the fence normally is | + | * There is a switch on the router |
| - | * Use the handle/tool in the socket indicated in the video to raise the collect | + | * Use either |
| + | * The collet should lock (i.e. not be able to rotate) once the collet is raised above the router table | ||
| + | * This is an additional safety to ensure the router cannot be switched on when changing the router bit | ||
| * Loosen using the 24 mm Spanner | * Loosen using the 24 mm Spanner | ||
| * Put in router bit | * Put in router bit | ||
| Line 121: | Line 123: | ||
| * Lower collet | * Lower collet | ||
| * Remove the handle | * Remove the handle | ||
| - | * Once the bit has been changed and the collet is below the table then lockout box can be tapped | + | * Once the bit has been changed and the collet is below the table (and therefore able to rotate), slide the clear safety cover across the switch on the router motor back and switch it on |
| + | * the lockout box can now be tapped | ||
| {{ : | {{ : | ||