Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
| equipment:metalshop:titanpillardrill:usinglargebits [2026/06/29 18:08] – [4. Return it to its holder on the wall.] ralawrence | equipment:metalshop:titanpillardrill:usinglargebits [2026/06/29 18:08] (current) – [5. Clean the Pillar Drill.] ralawrence | ||
|---|---|---|---|
| Line 82: | Line 82: | ||
| Match the size (e.g., 10.0mm) engraved on the shank of the bit to the corresponding labelled hole of drill rack. Storing bits in their dedicated holder prevents them from rolling off the table and falling onto the concrete floor (which chips and dulls the cutting tip). It also ensures that the next user can instantly find the correct size, saving time and preventing people from using the wrong bit because they couldn' | Match the size (e.g., 10.0mm) engraved on the shank of the bit to the corresponding labelled hole of drill rack. Storing bits in their dedicated holder prevents them from rolling off the table and falling onto the concrete floor (which chips and dulls the cutting tip). It also ensures that the next user can instantly find the correct size, saving time and preventing people from using the wrong bit because they couldn' | ||
| - | ====== 5. Clean the Pillar Drill. | + | ==== 5. Clean the Pillar Drill. ==== |
| Using a stiff brush and a rag, sweep all metal chips off the drill table, out of the T-slots, and off the base plate. Wipe down the vertical column with an oily rag to prevent rust, and wipe any excess cutting fluid off the chuck. | Using a stiff brush and a rag, sweep all metal chips off the drill table, out of the T-slots, and off the base plate. Wipe down the vertical column with an oily rag to prevent rust, and wipe any excess cutting fluid off the chuck. | ||