Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
| equipment:metalshop:metallathe:howto:cutthreadsl2r [2025/04/20 12:40] – drew | equipment:metalshop:metallathe:howto:cutthreadsl2r [2025/04/20 12:42] (current) – drew | ||
|---|---|---|---|
| Line 11: | Line 11: | ||
| Decide on what thread you want to cut:- | Decide on what thread you want to cut:- | ||
| - | Size i.e. M20 | + | Size i.e. M20 by 2.5mm. |
| - | + | ||
| - | Thread i.e. 2.5mm, is usually set by size | + | |
| Thread direction, i.e. right-handed (the norm), I assume this in the guide below. | Thread direction, i.e. right-handed (the norm), I assume this in the guide below. | ||