Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
| equipment:3d_printer_room:prusacoreone [2026/05/06 16:39] – Updated after the Core One + and hardened nozzle upgrades tiff_davis | equipment:3d_printer_room:prusacoreone [2026/05/06 16:44] (current) – changing the "do not change the nozzles" part to stand out more tiff_davis | ||
|---|---|---|---|
| Line 14: | Line 14: | ||
| * Do not touch the nozzle or heatbed when the printer is printing or warming up. The nozzle can reach 300°C and the heatbed can reach over 100°C. | * Do not touch the nozzle or heatbed when the printer is printing or warming up. The nozzle can reach 300°C and the heatbed can reach over 100°C. | ||
| * Supervise at least the first few layers of the print and notify on the forum in the "long 3D print notifications" | * Supervise at least the first few layers of the print and notify on the forum in the "long 3D print notifications" | ||
| - | * Report problems on the forum as soon as they arise. Do not attempt to disassemble the 3D printers | + | * Report problems on the forum as soon as they arise. Do not attempt to disassemble the 3D printers unless you have been authorised to do so. The nozzles cannot be unscrewed without disassembly, |
| + | * Do not try and swap the nozzles without mentioning on the forum and looking up a specific guide on how to do so. | ||
| * Before using ABS, ASA, HIPS, or PA filament make sure the top vent is closed and the chamber fans are running. | * Before using ABS, ASA, HIPS, or PA filament make sure the top vent is closed and the chamber fans are running. | ||