Differences

This shows you the differences between two versions of the page.

--- access_control:door [2026/01/25 23:03] – created aaronds
+++ access_control:door [2026/01/25 23:37] (current) – aaronds
@@ Line 15: / Line 15: @@
 When the door is in a "ready" state the red status LED will appear to "breath" getting brighter then dimmer over a couple of seconds. If the box was off it will take 10 seconds after it has been turned on before the LED will start to show.
-To unlock the door hold your keycard or fob over the NFC logo on the right hand side of the control panel. Do not touch any other part of the door while unlocking. Do not pull on the door while unlocking.
+==== Opening ====
+To unlock the door hold your key-card or fob over the NFC logo on the right hand side of the control panel. Do not touch any other part of the door while unlocking. Do not pull on the door while unlocking.
 The door will then contact the server and check if you have passed the required inductions to use the tool.
@@ Line 30: / Line 33: @@
   * Turn it off and on again
+If the door is able to validate your induction status you will likely hear the mechanism unlock. When the door is ready to be opened the orange unlocked indicator will light up. Do not try to open the door until the indicator is lit. The red status LED will also turn off.
+{{:access_control:acs_door_unlocked.png?400|}}
+Use the door handle to carefully open the door. Take particular care not to hit or otherwise stress the acrylic window, it is the most expensive component in the whole system.
+While the door is open the orange unlocked indicator will flash.
+In general the door should be left closed but unlocked while you use the tool, this means the tool will be shown as in-use on the status page.
+==== Closing ====
+Carefully place the tool and any other items remove from the box back inside the box. Close the door gently, make sure not to stress the acrylic. If the door doesn't appear to close completely check the frame to ensure nothing is trapped and try again.
+The flashing orange unlocked indicator should stop flashing when the door is closed correctly. If it doesn't stop flashing, push gently on the door handle until the door closes properly.
+To lock the door push firmly on the "Logout" button until the orange unlocked indicator turns off.
+If the door refuses to lock contact the committee on the forum.