Metal Lathe Accessories

Work Holding

5“ Pratt Burnerd 3 jaw chuck - this is very good, look after it.
5” 4 jaw independent chuck
A wooden ways board to protect the ways when changing the chuck or fitting heavy work.
Drive plate for turning between centres.

Tailstock

Live centre for tailstock - good but a bit blunt.
Dead centre - with carbide tip.
Half dead centre.
Keyless Chuck for Tailstock.
Morse taper reducing sleeves.

Steady Rests

Travelling steady rest.
Fixed steady rest - Below are a couple of great videos explaining how to set up and use the fixed steady.

Cutting

Parting off tools.
Some Carbide insert cutting tools.
Lots of HSS for making cutting tools.
Some reamers

Measurement and Metrology

2 Axis Mitutoyo DRO Digital XY readout
A digital Metric indicator and small stand.
A dial test indicator.
An imperial dial indicator and stand.
Digital callipers - on loan from Drew.
Large and Small precision Levels .

Thread Cutting

Thread Dial Indicator.
Tap Follower.
Die Holder.
A range of thread cutting carbide tools.
Change gears in the bottom draw for a wider range of screw cutting options.

Misc

A turret stop to go on the carriage.