Differences

This shows you the differences between two versions of the page.

--- equipment:woodshop:charnwood_pt10s_planer_thicknesser [2024/06/17 20:08] – nough
+++ equipment:woodshop:charnwood_pt10s_planer_thicknesser [2024/11/19 21:42] (current) – external edit 127.0.0.1
@@ Line 35: / Line 35: @@
   * **NO scaffold boards or dirty wood.** (Cement, dirt and grit will damage and blunt the blades.)
-===== Basic Guidelines (Copied from Manual) =====
+==== Manual ====
+Much of the below information is taken from the manual. That said, please read the whole page prior to taking your induction!
+{{ :equipment:woodshop:pt10s-owners-manual.pdf |PT10S Manual}}
+===== Basic Guidelines =====
 Before starting, check that the dust extractor is not full. If it is full, take the bag out to the building's green skip and fit a new one.
 Before starting, check that you have enough infeed and outfeed space. If not, you will need to move the planer thicknesser
-When you have finished with the Planer Thicknesser, clean it and return it to planing mode.
+When you have finished with the Planer Thicknesser, clean it and return it to planing mode. You will likely need to vacuum it, as the dust extractor does not extract 100% of dust.
@@ Line 115: / Line 120: @@
   - Set the machine up for planing.
   - Identify the flattest of the two wider faces on the timber. (Face 1 on diagram)
-  - {{  :equipment:woodshop:planerthicknesserwoodguide.png?200|}}
+  - {{:equipment:woodshop:planerthicknesserwoodguide.png?200|}}
   - If there is a concave side and a convex side, you should plane the concave side first.
-  - {{ :equipment:woodshop:pt10s:convex_concave.png?200|}}
+  - {{:equipment:woodshop:pt10s:convex_concave.png?200|}}
   - Pass that side over the planer as many times as necessary until a flat and smooth finish is achieved.
   - Hold the planed side (1) firmly against the side fence and pass the narrow side (Face 2 on diagram) over the planer as many times as necessary until a flat and smooth finish is achieved.
@@ Line 125: / Line 130: @@
   - Finally, pass the timber through the thicknesser with the planed narrow side (Face 2 on diagram) facing down against the bed. Continue until the desired thickness for the timber is reached.
-=== Manual ===
-{{ :equipment:woodshop:pt10s-owners-manual.pdf |PT10S Manual}}
-===== Induction =====
-The default configuration should be in planning mode this should be how it is left after each use when finished with after tidy up.
-=== Thicknesser ===
-When using in thicknesser mode ensure your hands are clear of the entry point of the thicknesser. If required to process smaller pieces of wood then ensure you use the push tools or small sled.
-Below how not to do it!
-{{:equipment:woodshop:pt10s:hand_inside.jpg?400|}}
-Below the correct way to do it!
-{{:equipment:woodshop:pt10s:sled.jpg?400|}}
-=== Planer ===
-Holder
-=== Clean up ===
-When your finished with your work make sure you vaccumm out all the planner all levels. Return to planer mode and ensure that the leave is locked in the correct position for planing.