Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
| equipment:hotworks:welder:induction_notes [2025/04/19 15:03] – ollie | equipment:hotworks:welder:induction_notes [2025/06/13 20:39] (current) – ollie | ||
|---|---|---|---|
| Line 68: | Line 68: | ||
| * Check there is sufficient wire left on the spool, of the correct type (gasless flux-cored) and diameter (0.8mm) | * Check there is sufficient wire left on the spool, of the correct type (gasless flux-cored) and diameter (0.8mm) | ||
| * Set the welding settings. Start point should be (for 2mm mild steel) | * Set the welding settings. Start point should be (for 2mm mild steel) | ||
| - | * Switch A – (toggle switch on left) switched to “Max”. Switch B – (rotary switch) set to 2. | + | * Switch A – (toggle switch on left) switched to “Max”. Switch B – (rotary switch) set to either 1 or 2. |
| * Wire speed set to 6. | * Wire speed set to 6. | ||
| * For thinner material, switch A set to " | * For thinner material, switch A set to " | ||
| * Attach earth clamp to table, or preferably the workpiece. | * Attach earth clamp to table, or preferably the workpiece. | ||
| * Plug in welder and switch on isolator and welder power switch | * Plug in welder and switch on isolator and welder power switch | ||
| - | * Make sure there’s about 5mm of wire protruding from the torch | + | * Make sure there’s about 5-10mm |
| __Performing a weld.__ | __Performing a weld.__ | ||