Differences

This shows you the differences between two versions of the page.

--- equipment:electronics:3dprinters:prusaxl [2025/10/06 17:10] – kit
+++ equipment:electronics:3dprinters:prusaxl [2025/12/20 15:44] (current) – ↷ Links adapted because of a move operation kit
@@ Line 1: / Line 1: @@
 ======  Prusa XL  ======
-{{ :equipment:cnc:prusaxl.png?400 |}}
+{{ equipment:laser:prusaxl.png?400 |}}
@@ Line 40: / Line 40: @@
 ===== Manual =====
-{{ :equipment:cnc:prusa3d_manual_xl_104_en.pdf |}}
+{{ equipment:laser:prusa3d_manual_xl_104_en.pdf |}}
 ===== USB Format =====
@@ Line 78: / Line 78: @@
       *   If the filament is not extruded and **PURGE MORE** doesn't help, repeat the loading procedure by choosing **RETRY**
-{{ :equipment:cnc:inserting_filament.png?600 |}}
+{{ equipment:laser:inserting_filament.png?600 |}}
 ===== Removing filament =====
@@ Line 87: / Line 87: @@
   - Once the extruder stops unloading the filament, remove it from the PTFE tube by hand. Please keep in mind that the process of unloading the filament strand from the extruder takes a few seconds. Do not pull hard on the filament when the unloading process is running. Check the printer's screen for information.
   - Make sure to secure the unloaded filament when you wind it up back onto the spool. If the end of the filament slips out, the spool may become tangled.
-{{ :equipment:cnc:unloading_filament.png?400 |}}
+{{ equipment:laser:unloading_filament.png?400 |}}
 ===== Accessories =====