Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
equipment:electronics:3dprinters:prusacoreone [2025/10/06 17:09] – kitequipment:electronics:3dprinters:prusacoreone [2025/12/20 15:44] (current) – ↷ Links adapted because of a move operation kit
Line 1: Line 1:
 ====== Prusa Core One ====== ====== Prusa Core One ======
  
-{{ :equipment:cnc:core_one.jpg?nolink&600 |}}+{{ equipment:laser:core_one.jpg?nolink&600 |}}
  
  
Line 88: Line 88:
   - Once the extruder stops unloading the filament, remove it by hand from the PTFE tube. The filament needs to be wound up on the spool and secured carefully so that it does not tangle up.   - Once the extruder stops unloading the filament, remove it by hand from the PTFE tube. The filament needs to be wound up on the spool and secured carefully so that it does not tangle up.
   - Make sure to secure the unloaded filament when you wind it up back onto the spool. If the end of the filament slips out, the spool may become tangled.   - Make sure to secure the unloaded filament when you wind it up back onto the spool. If the end of the filament slips out, the spool may become tangled.
-{{ :equipment:cnc:unloading_filament.png?400 |}}+{{ equipment:laser:unloading_filament.png?400 |}}
  
 ===== Accessories ===== ===== Accessories =====
  • equipment/electronics/3dprinters/prusacoreone
  • Last modified: 17 hours ago
  • by kit