Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
| equipment:cnc:prusaxl [2024/11/22 17:41] – addition to the previous edit, updated the filament section to talk about abrasive filaments. tiff_davis | equipment:cnc:prusaxl [2025/02/18 20:01] (current) – samp20 | ||
|---|---|---|---|
| Line 22: | Line 22: | ||
| **Standard settings:** 1st colour, 2nd supports. These can be modified in the settings. You can use different types of filament within reason but consider the heat of the bed. | **Standard settings:** 1st colour, 2nd supports. These can be modified in the settings. You can use different types of filament within reason but consider the heat of the bed. | ||
| Always make sure the filament in each line matches that in the software. | Always make sure the filament in each line matches that in the software. | ||
| + | |||
| + | |||
| + | ===== Etiquette ===== | ||
| + | |||
| + | Only two 3D printers should be used by a member at any one time. If it is especially busy consider using one to be considerate of others. | ||
| ===== Manual ===== | ===== Manual ===== | ||