Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
| equipment:cnc:mill:induction-prompts [2024/06/05 22:50] – aaronds | equipment:cnc:mill:induction-prompts [2025/06/08 18:51] (current) – aaronds | ||
|---|---|---|---|
| Line 58: | Line 58: | ||
| Demonstrate clamping workpiece into vice. | Demonstrate clamping workpiece into vice. | ||
| - | ==== Indicating X and Y ==== | + | ==== Indicating X and Y (Mechanical Wobbler) |
| Discuss using mechanical wobbler to indicate in the workpiece. Point out draw with tools including wobbler. | Discuss using mechanical wobbler to indicate in the workpiece. Point out draw with tools including wobbler. | ||
| Line 69: | Line 69: | ||
| Remove wobbler | Remove wobbler | ||
| + | |||
| + | ==== Indicating X and Y (3D Probe) ==== | ||
| + | |||
| + | Probe is in the bottom draw of the CNC cabinet. | ||
| + | |||
| + | Install probe in spindle, connect probe to socket on front panel, note notch for correct orientation. | ||
| + | |||
| + | Run tool change to set tool height. | ||
| + | |||
| + | Demonstrate selecting axis, holding down " | ||
| + | |||
| + | * FN+M4 -> Probe +ve | ||
| + | * FN+M8 -> Probe -ve | ||
| + | * FN+M1 -> Set X to 0 | ||
| + | * FN+M5 -> Set X to X / 2 | ||
| + | * FN+M2 -> Set Y to 0 | ||
| + | * FN+M6 -> Set Y to Y / 2 | ||
| + | |||
| + | Recommend setting origin to centre of stock. Demonstrate setting X axis. Guide inductee though setting Y. | ||
| + | |||
| ==== Tool Setup ==== | ==== Tool Setup ==== | ||