Differences

This shows you the differences between two versions of the page.

--- equipment:cnc:mill:induction-prompts [2024/06/05 22:46] – aaronds
+++ equipment:cnc:mill:induction-prompts [2025/06/08 18:51] (current) – aaronds
@@ Line 58: / Line 58: @@
 Demonstrate clamping workpiece into vice.
-==== Indicating X and Y ====
+==== Indicating X and Y (Mechanical Wobbler) ====
 Discuss using mechanical wobbler to indicate in the workpiece. Point out draw with tools including wobbler.
@@ Line 69: / Line 69: @@
 Remove wobbler
+==== Indicating X and Y (3D Probe) ====
+Probe is in the bottom draw of the CNC cabinet.
+Install probe in spindle, connect probe to socket on front panel, note notch for correct orientation.
+Run tool change to set tool height.
+Demonstrate selecting axis, holding down "FN" on pendant and pressing "M-" function keys to initiate probe.
+  * FN+M4 -> Probe +ve
+  * FN+M8 -> Probe -ve
+  * FN+M1 -> Set X to 0
+  * FN+M5 -> Set X to X / 2
+  * FN+M2 -> Set Y to 0
+  * FN+M6 -> Set Y to Y / 2
+Recommend setting origin to centre of stock. Demonstrate setting X axis. Guide inductee though setting Y.
 ==== Tool Setup ====
@@ Line 133: / Line 153: @@
 Emphasise “pause early”. Very easy to restart from a pause. If at all uncertain, hit pause and figure it out.
 Avoid getting tired or distracted by other things in the CNC room.
+Ensure every person being inducted has:
+  * Used the wobbler to set one axis
+  * Changed tool and set tool height
+  * Indicated the Z position with paper trick
+  * Started, paused, stopped a g-code program
 ===== Clearing Up =====