Differences

This shows you the differences between two versions of the page.

--- equipment:cnc:laser:software [2025/04/21 11:48] – robert.simpson190
+++ equipment:cnc:laser:software [2025/04/21 11:49] (current) – robert.simpson190
@@ Line 57: / Line 57: @@
 This applies to FreeCAD v1.0.
-The TechDraw workbench can be used to generate 2D views which can then be exported as DXF files. However, there is no option to select the DXF version. The exported files contain the AC1009 directive which the AutoDesk website says corresponds to R11/R12. If the 'Export TechDraw views as blocks' is //deselected//, LaserCut will load the file but nothing is displayed. The file can be imported into LibreCAD and then exported as DXF-R14 which is readable by LaserCut.
+The TechDraw workbench can be used to generate 2D views which can then be exported as DXF files. However, there is no option to select the DXF version. The exported files contain the AC1009 directive which the AutoDesk website says corresponds to R11/R12. If the 'Export TechDraw views as blocks' is //deselected//, LaserCut will load the file but nothing is displayed. However, the file can be imported into LibreCAD and then exported as DXF-R14 which is readable by LaserCut. Note this does not work if the 'Export TechDraw views as blocks' was selected during the FreeCAD export.