Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
| equipment:cnc:laser-xtool-s1:lightburn [2024/11/04 20:19] – aaronds | equipment:cnc:laser-xtool-s1:lightburn [2024/11/19 21:42] (current) – external edit 127.0.0.1 | ||
|---|---|---|---|
| Line 12: | Line 12: | ||
| * The Air Assist dial is set to " | * The Air Assist dial is set to " | ||
| - | {{: | + | {{: |
| The workspace should look similar to the photo above. If there is any damage to the laser especially to the lid do not continue. Report the situation on the discourse forum and label the laser as damaged. | The workspace should look similar to the photo above. If there is any damage to the laser especially to the lid do not continue. Report the situation on the discourse forum and label the laser as damaged. | ||
| - | Switch on the laser via the isolator switch | + | Switch on the laser via the isolator switch |
| The extraction system should also turn on at the same time. Do not continue if it doesn' | The extraction system should also turn on at the same time. Do not continue if it doesn' | ||
| Line 104: | Line 104: | ||
| {{: | {{: | ||
| - | The number > 0 represents the step in millimetres to take towards the material for each " | + | The number > 0 represents the step in millimetres to take towards the material for each " |