Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
| equipment:adt:brother_b755_mk2 [2026/05/13 20:56] – [How to Thread the Machine] laughitup | equipment:adt:brother_b755_mk2 [2026/05/13 21:04] (current) – [Raising and Lowering the Presser Foot] laughitup | ||
|---|---|---|---|
| Line 91: | Line 91: | ||
| **Presser Foot Lift Lever:** Use the black presser foot lift lever at the back of the machine. The benefit of this method is you can lock the presser foot in the lifted position, which you can't with the knee lift. | **Presser Foot Lift Lever:** Use the black presser foot lift lever at the back of the machine. The benefit of this method is you can lock the presser foot in the lifted position, which you can't with the knee lift. | ||
| + | |||
| + | Top Tip: If you are struggling to remove your work piece from the machine as the threads are getting stuck - try advancing the hand wheel so the needle goes all the way up and then just starts coming down again. | ||
| Line 137: | Line 139: | ||
| - To load the bobbin case the needle needs to be in its highest position. If it is not, turn the hand wheel until it is. | - To load the bobbin case the needle needs to be in its highest position. If it is not, turn the hand wheel until it is. | ||
| - | - To load the bobbin case the gap in the rim of the case needs to be pointing up. Align the hole on the opposite side of the case to the lever with the bobbin axle under the machine. The bobbin case should positively click into place. | + | - To load the bobbin case the gap in the rim of the case needs to be pointing up. Align the hole on the opposite side of the case to the lever with the bobbin axle under the machine. The bobbin case should |
| - Finally, slide the bobbin access plate back into place. | - Finally, slide the bobbin access plate back into place. | ||