Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
| equipment:adt:brother_b755_mk2 [2026/05/13 20:54] – [Overview] laughitup | equipment:adt:brother_b755_mk2 [2026/05/13 21:04] (current) – [Raising and Lowering the Presser Foot] laughitup | ||
|---|---|---|---|
| Line 81: | Line 81: | ||
| - The thread now goes down and around the needle thread tension plate. Make sure the thread is set down between the plates and not just sitting in the v between the two plates. The thread then goes around the round metal ' | - The thread now goes down and around the needle thread tension plate. Make sure the thread is set down between the plates and not just sitting in the v between the two plates. The thread then goes around the round metal ' | ||
| - Thread the thread down through the 'pigs tail' guide before clipping it behind the clip at the bottom of the needle attachment clamp, just above the top of the needle. | - Thread the thread down through the 'pigs tail' guide before clipping it behind the clip at the bottom of the needle attachment clamp, just above the top of the needle. | ||
| - | - Lastly, thread the thread through the needle eye from left to right. Wahoo, you've done it! | + | - Lastly, thread the thread through the needle eye from **left to right** (this is important). Wahoo, you've done it! |
| Line 91: | Line 91: | ||
| **Presser Foot Lift Lever:** Use the black presser foot lift lever at the back of the machine. The benefit of this method is you can lock the presser foot in the lifted position, which you can't with the knee lift. | **Presser Foot Lift Lever:** Use the black presser foot lift lever at the back of the machine. The benefit of this method is you can lock the presser foot in the lifted position, which you can't with the knee lift. | ||
| + | |||
| + | Top Tip: If you are struggling to remove your work piece from the machine as the threads are getting stuck - try advancing the hand wheel so the needle goes all the way up and then just starts coming down again. | ||
| Line 137: | Line 139: | ||
| - To load the bobbin case the needle needs to be in its highest position. If it is not, turn the hand wheel until it is. | - To load the bobbin case the needle needs to be in its highest position. If it is not, turn the hand wheel until it is. | ||
| - | - To load the bobbin case the gap in the rim of the case needs to be pointing up. Align the hole on the opposite side of the case to the lever with the bobbin axle under the machine. The bobbin case should positively click into place. | + | - To load the bobbin case the gap in the rim of the case needs to be pointing up. Align the hole on the opposite side of the case to the lever with the bobbin axle under the machine. The bobbin case should |
| - Finally, slide the bobbin access plate back into place. | - Finally, slide the bobbin access plate back into place. | ||