Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
| equipment:3d_printer_room:3dprinters:home [2026/03/31 20:04] – ↷ Page moved from equipment:electronics:3dprinters:home to equipment:3d_printer_room:3dprinters:home kit | equipment:3d_printer_room:3dprinters:home [2026/03/31 20:07] (current) – removed kit | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ====== 3D Printers ====== | ||
| - | |||
| - | All Hackspace 3D printers use 1.75mm filament. Most filaments such as PLA, PETG, FLEX etc are supported. Do not use filaments that require a nozzle temperature above 285°C such as polycarbonate. | ||
| - | |||
| - | ABS, ASA, HIPS and PA **CANNOT** be used on any of the printers without an advanced filtration system, please contact committee well in advance if this is needed as a proposal will be needed. | ||
| - | |||
| - | Please be considerate of others and only use ONE printer at any one time. | ||
| - | |||
| - | |||
| - | <nspages -tree -r -exclude -subns -pagesInNs -h1 -textNs="" | ||