====== Bench Pillar Drill  ======
 
<callout title="Crush / Entanglement" type="warning" icon="true"> This equipment is hazardous to the user or those around them, take care during use.</callout>
 
<callout title="PPE Required" type="primary" icon="true"> This equipment requires the use of eye protection and may require hearing protection and respiratory protection during use.</callout>

Bench pillar drill
240 volt single phase motor

===Risk assessment===
TBC


===== Instructions =====

=== Safety ===
  * Be aware of other people around you. Don't bump into them and be respectful of usage space around the equipment.
  * Only drill vertically. This is not a mill / CNC machine. Things could go very wrong if the work piece is moved while drilling into it.
  * Tie long hair back (preferably tucking it into clothing). Be aware of beards if appropriate.
  * Don't wear loose clothing that might catch on any moving part.

=== Drill bits ===
  * These are located on the wall behind the drill.
  * If a drill bit is broken during normal usage, replace with a spare drill bit from the "Spare bits" storage box. Do not use the spares if there are still suitable bits available.
  * If there are no more spares, make a note of the drill bit size and comment on the Discourse to get more stock. 
  * The drill bits are good for general purpose use.

=== Usage ===
  - If using Large drill bits see extra instructions below.
  - Move the working platform up or down by loosening the handle attached to the left of the platform.
  - Insert the relevant drill bit. Ensure the shank of the drill bit goes all the way into the chuck.
  - Tighten the chuck using the chuck key. 
  - Align the hole in the platform with the drill bit. This is so that the surface won't be damaged if you do drill through the work piece.
  - Secure the work piece using the metal vice clamp to hold the piece so your hands don't have to.
  - Turn on machine with the start button.
  - Slowly use the three handles on the side to lower the drill into the work piece.
  - Rotate the handles **slowly** to remove the drill bit upwards from the work piece - do **not** just let go of the handles.

=== Changing Speed ===
  * If you must turn off the drill by hitting the stop button and change the belt setting. When finished put it back to the default setting.

=== Tidying up ===
  * Wait for a while to ensure that the drill bit is cool. If you can hold onto the bit for a long time (i.e. at least 3 seconds) with your bare hands, that is cold enough.
  * Remove drill bit from chuck. and put all drill bits back into their respective places.
  * Brush the drill and platform to remove excess material. Sweep area around drill press and bin the rubbish.

===Manuals===
????


===Using Large Drill Bits===
[[equipment:metalshop:pillardrill:usinglargebits]]