====== Metal Lathe Accessories ======

===Work Holding===
  *5" Pratt Burnerd 3 jaw chuck - this is very good, look after it.\\
  *5" 4 jaw independent chuck\\
  *A wooden ways board to protect the ways when changing the chuck or fitting heavy work.
  *Drive plate for turning between centres.\\

===Tailstock===
  *Live centre for tailstock - good but a bit blunt.\\
  *Dead centre - with carbide tip.\\ 
  *Half dead centre.\\
  *Keyless Chuck for Tailstock.\\
  *Morse taper reducing sleeves.\\


===Steady Rests===
  *Travelling steady rest.\\
  *Fixed steady rest - Below are a couple of great videos explaining how to set up and use the fixed steady. \\
{{youtube>PoB9o_EBdj4?}}
{{youtube>J02ricbIIvc?}}

===Cutting===
  *Parting off tools. \\
  *Some Carbide insert cutting tools. \\
  *Lots of HSS for making cutting tools. \\
  *Some reamers\\

===Measurement and Metrology===
  *[[equipment:metalshop:metallathe:lathedro|2 Axis Mitutoyo DRO Digital XY readout]]\\
  *A digital Metric indicator and small stand.\\
  *A dial test indicator.\\ 
  *An imperial dial indicator and stand.\\
  *Digital callipers - on loan from Drew.\\
  *Large and Small precision Levels .\\

===Thread Cutting===
  *[[equipment:metalshop:metallathe:tdi|Thread Dial Indicator.]]\\
  *Tap Follower.\\
  *Die Holder.\\
  *A range of thread cutting carbide tools.
  *Change gears in the bottom draw for a wider range of screw cutting options.\\

===Misc===
  *A turret stop to go on the carriage.